Hello @MariMakes,
I have deactivated the power loss recovery for exactly this reason if that is what you mean. Is there any other interruption recovery that I should know of?
I have never looked at the meshcount. I always just import the stl from Inventor to Cura and that always works. Well, until now. Maybe I should look into that.
Which software would be the right one for adjusting the meshcount? I think Angus from MakersMuse uses MeshMixer, would that be a good one? I don't think that I can do that in Cura, can I?
I have worked a lot with the firmware. Could I have messed up anything there? I think there were some buffer settings or something like that.
Thank you very much.