OkieVet918

New member

Personal Information

The recent visitors block is disabled and is not being shown to other users.

Some STL files don't open on the build plate.

OkieVet918 replied to OkieVet918's topic in UltiMaker Cura

Yea, I kind of figured it was that, however resizing didn't make a difference.
Some STL files don't open on the build plate.

OkieVet918 replied to OkieVet918's topic in UltiMaker Cura

I did that, and it doesn't put it on the build plate. Any other ideas? I appreciate the reply.
Some STL files don't open on the build plate.

OkieVet918 posted a topic in UltiMaker Cura

I have Cura 5.1.1, and "Automatically drop models to the build plate" is enabled, however I have several STL files that are off to the side and I can't get them to place on the build plate. Thoughts, ideas??