Manfred_Schwarz

Thank you. https://github.com/Ultimaker/Cura/issues/13604

Hello, I work with latest Cura 5.2.0 and latest firmware of S5. In my job are 4 different parts (attached). Until about 15% of the highness there is the second printer head necessary for the support of Breakaway. Above of 15% there would be only head 1 necessare because there is no breakaway needed. But the head is each layer driving to the right side and switch to head 2, switches immediately back to head one and prints the next layer. This needs a lot of time. Have I made a mistake in the configuration? Please check this situation. Thank you and regards, Manfred UMS5_SecuExBatt.3mf UMS5_SecuExBatt.ufp