Hiabst

Set the weight to about 800g as its not full and print time to 0. That would be the correct settings right? I also use the GUI to write but when i read the tag i used the command line once to check.The GUI shows everything is correct when i read the tag

I just did a Factory reset and i can choose my Material now on the UM3, NFC still isnt working tho : ( @CarloK do you have any ideas regarding my Log i sent two posts ago?

Hey, thanks for the reply. I read it trough again because the last time was almost 2-3 weeks ago i somewhat understand it again now. I attached what i found in my logs, i really have no idea of what i should be searching for but here were a few errors with the NFC at the time i was at my printer. Folder with the NFC files would be /usr/share/griffin/nfc . Best Regards, Hiabst NFC.log

Im getting this from the Spoolmaker.py Connected to NFC Tag. ATR Response = 3B 8F 80 01 80 4F 0C A0 00 00 03 06 03 00 03 00 00 00 00 68 UID = 04 67 39 92 66 5A 80 status = 90 00 data=[4, 103, 57, 146, 102, 90, 128] Finding: 611699d6-1466-4bd8-80a1-adf87de07159 that would be correct right? I want to eliminate the possibility that my NFC Reader isnt working correctly. And I just found out that the String above "unknown" is the Serial Number of the Tag. Edit: just found out that all my tags have the same serial Number(UID). But the original Tag from a Ultimaker spool should still work after i changed the GUID right ?

Hi, im not sure if i know not enough linux, but tried with "grep" and "find" but couldnt find any files which contain the word NFC or end in .py . I think The Printer hasnt had an update in a minute i think imma try to update it rn. Edit: I checked the currently installed Firmware and its from May(?) 2019 lol. Gotta tell my coworkers to update th printer more. Edit2: still not finding any files : (

I will do this tomorrow. My workday is almost over but thanks for the help, much appreciated.

Nope, The NFC tags still dont work i checked if the XMLs are on the Printer, checked if the GUID is the only one. wrote it to my tag but the nfc reader doesnt pick it up / the NFC diagnosis says Unknown 😞

Hi, i already got it conected to my UM3 and it said that the materials were beeing sent over, but cant find them anywhere im gonna try fixxing it via your link, thank you.

Dont see that Option for my UM3 in cura 5.1.1.

So got it connected to my network after IT patched my port. Cura showed a message that there are materials getting sent over but they arent showing up in my UM3 anyone got a idea what the problem could be ?

Hey, im using this Printer for work and i have the "job" to eliminate User errors. After two weeks of trying everything i finally found out that my colleague sent me the wrong driver for my nfc reader🙄. Now its working as i can read and write Ntags. The Problem is that our printer isnt connected to the Network and i would need to sync the Materials to the UM3 for it to work right? Tested the Tags on the UM3 and it only shows "UNKNOWN" and a string of letters and numbers. even tried to export the Ultimaker PLA file and write it onto the tag but also shows unknown. Its My last week at this workplace so i would really like to finish this project or atleast as much finished so that they only need to connect the UM3 to the Network and its working. Could someone Maybe try to write a Ultimaker Filament onto a Tag and remove the Printer from the network? Would be greatly appreciated. Best Regards, Florian