Hey guys,
I've tried to print a lid for a box. But Cura is always filling out the empty space under the lid with infill. In Addition Cura sets a bottom layer.
Figure 1: Preview of the lid at layer 23
Figure 2: .stl-file in Prepare
All the boxes under Mesh-fixing are not enabled (I've read these tipps in another forum).
Furthermore the .stl-file has no errors according to the mesh-fixer Add-on in Cura and Meshmixer.
I hope that you can help me.
The .stl-file and the .3mf file are attached.
Best regards
Maik
Norbert Deckel.stl CCR10_Norbert Deckel.3mf