Jump to content

jadoglio

New member
  • Posts

    6
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

jadoglio's Achievements

1

Reputation

  1. Thank You. Appreciated very much. That is exactly what it was.
  2. When I send a g code file from Cura (latest version) to my printer (Voron 2.4r2 running RepRap latest version) it is adding the following to the g code to the file that sets the flow rate to 110. I have no idea why I cant find anything in slicer settings, start.g or the slicer starting g-code that would cause it. The entire file this was taken from is also attached. Any suggestions? Thanks ;LAYER_COUNT:564 ;LAYER:0 ;TYPE:CUSTOM LAYER M221 S110 M117 Flow S110 M107 M204 T1800 M566 X1800 Y1800 G1 F600 Z0.58 test.gcode
  3. One other note. I probably did not need to reboot. I just turned Fancy Zones on and Cura stopped responding. Then I turned it off and everything responded as normal. Power Toys v.0.65.0
  4. Thanks for the quick reply and links. After reviewing the links I remembered I installed Power Toys about the time the problem happened. I had not made a connection before that. I turned off Fancy Zones, rebooted, started Cura, installed Sidebar GUI and everything worked as it is supposed to. There was definately a conflict with the Fancy Zone app for sure. Thanks again.
  5. I have been using the Sidebar GUI since it was published. It is a great add-in. When I upgraded to 5.2.1, one the add-in was released I Installed it and it worked fine. About a month ago, Cura became so slow to do anything it was unusable. It would boot normally but when I clicked on any button it would basically take over a minute to process a command. I had no idea why and I finally started removing plug ins. Once I removed Sidebar Gui Cura stated responding normally. I recently reinstalled it to see if it would work but I got the same result and had to uninstall it again. In researching this I can't seem to find anyone else with this problem. Anyone have any ideas why this is happening or how to fix it.
×
×
  • Create New...