shiang1311
-
Posts
4 -
Joined
-
Last visited
shiang1311's Achievements
0
Reputation
-
Bridge settings: https://imgur.com/BiVzTyq Line: https://imgur.com/a/R89Ucs8 Flow: https://imgur.com/a/hnTvKgI Speed: https://imgur.com/a/o5JY6x2
-
Printer: Ultimaker S5 Material: Ultimaker tough PLA Firmware: 7.1.3.0 The first strand of a bridge always has very bad drooping, but the second strand is near perfect, lost on which setting to adjust. Using Cura slicer with experimental bridge settings enabled. Tried lower temps, lowering speed, and lowering flow rate. All seems to only apply to the strands after the first, leaving a single strand drooping from what is otherwise a very decent bridge.
-
Printer: Ultimaker S5 Material: Ultimaker tough PLA Firmware: 7.1.3.0 The first strand of a bridge always has very bad drooping, but the second strand is near perfect, lost on which setting to adjust. Using Cura slicer with experimental bridge settings enabled. Tried lower temps, lowering speed, and lowering flow rate. All seems to only apply to the strands after the first, leaving a single strand drooping from what is otherwise a very decent bridge.
-
I was performing some routine maintenance and saw there was a firmware update. Updated and now the touchscreen is not responding to touch at all. I've power cycled the entire system multiple time and still can't get it to work.
