Jump to content

Carlzberg

Member
  • Posts

    4
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker S5

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Carlzberg's Achievements

0

Reputation

  1. I’m not interested about cams or etc. I will be holding the plate with the gripper integrated to a robotic arm so i need a space for gripper to get inside but the screen on the middle of printer blocks it so if i can set manuel Z offset for higher coordinate, gripper can easily enter that gap.
  2. It wont be tall that much ever. So i dont have any worries about it. I was hoping to see an easier way actually but if i have to do it with coding i will but im not sure how to… or will it be possible even with coding… Do you have any idea/suggestions?
  3. Hello, My question is simple actually, i just want to stop the table/bed in the middle of printer. Let's say u sent a job to the printer and it finished, bed goes downwards and stops at the bottom. I don't want it to go all the way down. I want to set a Z coordinate manually so, when the job is done table stops there. I did try few things, like trying to add custom "End G-code" and sometimes it works, table stops exactly where i want it to be but eventually it goes down again no matter what. I know that, it needs to check where the table is with the switch at the bottom but it needs to do this in the beginning, not in the end. So, basically i want my printer to be able to stop in the Z coordinate which i will call... and it will stand there until i send a new job. I would be appriciated if you can share any idea/knowledge with me. Have a wonderful day!
×
×
  • Create New...