Jaamb

@gr5 So i’ve gone through your suggestions - tested the board and there is voltage showing. When the switch on the UM is in the off position voltage is detected but when switched to the on position this goes to zero. Also left the brick to power down and plugged back in but unfortunately still nothing.

Ok, thank you - i’ll give those suggestions a try.

Thanks @stu_le_brew Checked this out with a voltmeter and is fine. I should have mentioned in my original post, the board does have slight discolouration from heat but nothing appears burnt out. I’m just making sure i’ve checked everything I can before having to buy a new motherboard 😩

Hi, I have an UM2+ which has stopped working. Went to use it, power on, flipped the switch - nothing happening. I’ve searched online and found a few posts on this forum where other people have had issues with their printers not starting up. The power pack is working fine with the blue LED glowing. I’ve removed the motherboard and tried unplugging each plug and switching it on/off (as suggested on a different post). Still nothing happening. Does anybody have any further suggestions? Thanks