Hi!
I have created a test cube with a letter on top in OpenScad. Normally the letter should start exactly after the last top layer of the cube at 5mm. But the letter starts as outlined letter around 4 layers too early (inside the top layers) and creates a nasty surface.
OpenScad Example #1
cube([25,25,5]);
color("red")translate([4,2,5])linear_extrude(height = 2)
text("A", font="Arial", size=20);
I have also tried to lift the letter 0.2mm (one layer higher), but this results in a bug?!
-> layer18 (next layer after last top layer of the cube, letter is full, BUT nothing happens on this layer)
-> layer19 (now the letter starts)
OpenScad Example #2
cube([25,25,5]);
color("red")translate([4,2,5.2])linear_extrude(height = 2)
text("A", font="Arial", size=20);
So iam not sure if this is a OpenScad problem, or a Cura Problem. Any suggestions here?