UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Yes, I save time by doing that, I use Ultimaker Cura 5.3.0, and I have printed successfully with this printer, the print bed is a buildtak flexplate, I use lightweight PLA, and i use 200 degrees.
I use mac and Windows for ultimaker cura, how can I fix the filament not sticking, I use octoprint because sometimes I have to make a print for friends that can't wait long due to vacation so I use it to print fast, also the printer was gifted to me
okay so i feel like keeping it now, but how do i prevent it from bringing the priming blob to the center, also when i try to print directly from the octoprint dashboard it will not extrude the material even when its doing the printing job.
I did re level it, also i have an issue due to when i print using octoprint it will move the extruder to a place it can not go and when i get it working it will mess up, like cutting corners and bringing the filament it should print in the corner with it, i have not tested the octoprint after the reset
Hello, when I was setting up octoprint on my ultimaker2+ and when I switched the gcode to reprap it started messing up and cutting corners, I reset it and calibrated again, now when I was making a cube the base got stuck on the extruder, can someone help me?