Jump to content
Ultimaker Community of 3D Printing Experts

How can we use Nylon filament in Ultimaker 2 ?

Recommended Posts

Yes you can. quite a few people print with it. there are some found here: http://www.blackmagic3d.com/Nylon-s/1815.htm

if you click on the one you want then select printing parameters tab, this will give you recommended settings to use for that filament. Use those settings for starters then adjust from there to get the desired results your after.

  • Like 1

Share this post

Link to post
Share on other sites

Get yourself some Nylon bridge it's cheap and I've had some good results with it on my UL2 extended. Plus it doesn't off gas gnarly chemicals like arsenic n stuff while printing. that trimmer nylon is nasty stuff.

Print settings

Temp 240-242c

bed temp 70c

+PVA glue, glass, no tape

no active cooling (fan @ 0%).

.1-.2 layer height.

material flow 105-110%.

Use ALOT of brim, i may be over doing it, but in cura I'm a at 50-80) basically maxing out the brim on print bed. (why not? - Helps it from lifting and primes extruder).

For Support: I use 10-15% infill And add a bit to the support/print seperation. Xy I have at 1~1.5mm and Z @ .3-.45 dep on layers height.(use a multiple of 2x-3x)

For print infill I would rec as much as you can. 100% prints like a brick(yet still a bit flexible), 25% is a bit more spongy, all depends on your application. Note on large 100% infill parts you tend to see a bit more part warping.

Hope this helps,

Share this post

Link to post
Share on other sites

Why no fans?


Nylon is very prone to warping. Fans make the warping an even bigger problem by cooling the part non-uniformally. Paired with the fact that it doesn't stick that well to the plate, you could easily cause it to pull off the printbed simply having the fans on. Same with ABS prints.

  • Like 1

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!