Jump to content
Ultimaker Community of 3D Printing Experts

Layer Error


Roth
 Share

Recommended Posts

Posted · Layer Error

How come this one is looking good in Normal/Overhang/X-Ray but is not complete in the Layer Tab? It wouldn't be able to print the entire thing correctly as far as I can see.

I'm completely new to this and I haven't had much success looking for solutions by searching everywhere. It would seem I'm not smart enough to figure out the problem.

Thanks in advance for help / guidance!

www.etaweb.dk/layer_error.amf

  • Link to post
    Share on other sites

    Posted · Layer Error

    It's too thin. I had to go down to a 0.18mm nozzle to get it to all show up. You can do that if you want - tell Cura you want 0.18mm shell and it will slice and it will work but it will be a bit underextruded because the actual nozzle is 0.4mm (not .18mm). You can then tell it to use flow of 200% and you will get an okay print. But ideally you should fix the cad model so the walls are at least 0.8mm thick.

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...