Jump to content
Ultimaker Community of 3D Printing Experts
Mirobieb

Filament is leaking above the heather block

Recommended Posts

We have a brand new UMO+. The first prints looked fine, but we probably made an error when we putted the nozzle in the heather block.

Now it's leaking filament above the heather block.

I tryed to fix it. But because there's filament every were I can't get it loose or tighter.

Is there a trick to solve this problem.

I think I have to get it all loose en clean it and then put it together again.

But i can't get it loose

Mirobieb

Share this post


Link to post
Share on other sites

I used bottle of air to push the leaked filament with the head hot. But for safety reasons this is something you shouldn't do. But it worked for me. But don't do it :)

After that it was just a matter of atomic pull and tight the nozzle properly. (Don't overdo or the bozzle/heater block) can suffer.

Edited by Guest

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 117 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!