Jump to content
Ultimaker Community of 3D Printing Experts

Help with installing IRobertI's feeder


Recommended Posts

Posted · Help with installing IRobertI's feeder

I have printed IRobertI's feeder for the UM2, bought the necessary parts, but the thing that had me scratching my head was that if I remove the four screws holding the default feeder in place, won't the motor drop down? If yes, how does one replace the feeder?

  • Link to post
    Share on other sites
    Posted · Help with installing IRobertI's feeder

    Stick you finger in the hole where the braided cable comes out to hold it up. Then when the feeder is off, pull the knurled drive and insert a screw to hold it in place till you are ready to install the next bit.

  • Link to post
    Share on other sites
    Posted · Help with installing IRobertI's feeder

    Tuto by @didierklein

    link

  • Link to post
    Share on other sites
    Posted · Help with installing IRobertI's feeder

    I agree with neotko, just remove the white cover plate and save yourself any headache. Just make sure you don't pinch any wires when you re-attach the motor.

  • Link to post
    Share on other sites
    Posted · Help with installing IRobertI's feeder

    Fantastic stuff! Much appreciated.

  • Link to post
    Share on other sites
    Posted · Help with installing IRobertI's feeder

    Well, I followed all your helpful advice and it turned out that replacing the feeder was really very simple. Far simple than I thought it would be, and I should have done it ages ago since it if far better than the stock feeder.

    I was struggling with nylon (Taulman Bridge) and Robert's feeder makes it a doddle. Also the quick release is brilliant.

    So, thank you Robert. And if you are reading this and wonder if you should go ahead and change your stock feeder, then let me encourage you to do so.

    I fail to see why Ultimaker have not incorporated your ideas into their feeder, it is that good!

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...