Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
jeremie

Feature request: support for DS1820 temperature sensor?

Recommended Posts

Could Marlin and marlin autobuild support the cheap one-wire digital dallas DS1820 (or DS18B20) temperature sensor?

I used one on my heated bed controlled by a separate arduino pro mini because it is plain straightforward (no conversion nor lookup tables needed). Now that I know it's OK I would gladly control it from within a "regular" Marlin instead.

Share this post


Link to post
Share on other sites

The problem with the DS1820 is that it's range is only good up to 125 degrees C. That's not high enough for a hot-end and barely high enough fro a heated bed... And I wouldn't trust the plastic package for either scenario... I think even for a heated bed, if you want to do ABS or some more exotic materials you're going to really push the limits of the chip and if it fails or mis-reports you could have a fire-hazard. I would want much more head-room on the hot side myself.

Cheers,

Troy.

Share this post


Link to post
Share on other sites

I think the ability to enter in your own custom temp sensor tables would still be very useful in the marlin builder though.

As for thermal sensor reliability, even if we discount the chance of the temperature sensor failing (or use a 'fail safe' sensor) there is still the issue that the Arduino isn't a safety device and could be liable to control failure (and the issue with the boot-loader not allowing the watchdog to fire in the case of failure etc.). If you're really concerned about overheating or whatnot you ought to employ a last line of defence, which would probably best be a thermal fuse.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 80 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!