Jump to content
Ultimaker Community of 3D Printing Experts

Belt maintenance


Mithartridge
 Share

Recommended Posts

Posted · Belt maintenance

I assume you mean the long belt? If it's the short one you simply loosen the four screws that hold the stepper motor in place, press down firmly on the stepper and then re-tighten.

For the long belt; is the belt slack on both the upper and lower part of the loop? If it's just one side you'll have to loosen one of the pulleys that the belt runs across so that the pressure can equalise and then re-tighten the set screw again (firmly!).

If that's not it something must've happened inside the slide block. The slide blocks contain a spring that should keep the belt at the proper tightness automatically. Unfortunately it's difficult (if not impossible) to open those up without snapping at least one of the little tabs that keeps it shut so I would maybe try to improvise some external belt tensioning device. Not sure how much space there is to work with though.

  • Like 1
Link to post
Share on other sites

Posted · Belt maintenance

If the slack is on both the upper and lower part, get some of these:

spring.png.8e7a614c1391cb729011adb116d17761.png

Set the X and Y axis in the middle of the printer, loosen 1 pulley, add the spring above the slide block, tighten the pulley again.

Be sure that the most flat side is at the slide block, otherwise the belt can touch the axis.

spring2.png.5973084db6be37db80fad852c155b8e3.png

spring.png.8e7a614c1391cb729011adb116d17761.png

spring2.png.5973084db6be37db80fad852c155b8e3.png

  • Link to post
    Share on other sites

    • 1 year later...

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...