Jump to content
howardsmith

Using ColorFabb filament and struggling to get adhesive to bed as opposed to hot end

Recommended Posts

Posted · Using ColorFabb filament and struggling to get adhesive to bed as opposed to hot end

Using colorfabbs red and white PLA variants I'm struggling to get even the first layer to stick to the bed, it seems to want to follow the hot end and drag along until eventually it clogs and then gets deposited elsewhere on the bed. I've increased the temperature to 225 degrees on the nozzle, and 75 degrees on the bed, and that seems to have helped some but the problem remains (particularly the first layer - the brim I have to sacrifice all to often) and I can't help but imagine there must be a problem as I was printing at default settings previously fine.

I've re-seated and cleaned out the filament feeder, used the atomic method to clean the hot end, and tried so many failed prints I'm close to binning it.

Share this post


Link to post
Share on other sites
Posted (edited) · Using ColorFabb filament and struggling to get adhesive to bed as opposed to hot end

IMG_20150821_111823.thumb.jpg.823f898c74f23a76c062fb9eaccf7f46.jpg

5QM3LYv.jpg

this is with 100% infil

IMG_20150821_111823.thumb.jpg.823f898c74f23a76c062fb9eaccf7f46.jpg

Edited by Guest

Share this post


Link to post
Share on other sites
Posted · Using ColorFabb filament and struggling to get adhesive to bed as opposed to hot end

You might be overextruding. Colorfab colors and quality it's ok but more than one roll here had 1.76-1.72 variance. In you case being 2.85 it might be 2.90 etc. Pick a caliper and check the filament on sifferent places to be sure and adjust the filament size. I think on um2 it's on advanced settings? No idea, on my umo+ I change it in the slicer.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • January 22nd  | Ultimaker webinar 'Learn how to choose the right composite material'
      We’ll teach you how to choose the right composite material for your application in our new 40-minute webinar. You will learn how to: 
       
      • Make the perfect choice between glass and carbon fiber 
      • Identify more high-value applications that would benefit from composites 
      • 3D print advanced materials with the right settings 
      • Select the best materials for 3D printing end-use parts 
      • Use dual extrusion to take composite 3D printing to the next level 
      • 0 replies
    • Does your company use Ultimaker? Know one that does? Let us know!
      If your company uses Ultimaker in any capacity, we'd love to hear about it! If the story is there, and you're up for it, maybe we can work together to create a story that will be featured on the site. Here are examples of..
      • 18 replies
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!