Jump to content

Shifting error at same height on UMO

thixio1

By thixio1
in UltiMaker Cura

 Share

Recommended Posts

thixio1

thixio1 0

Posted
Posted · Shifting error at same height on UMO

Strange shiftig occurs after a certain height of the prints. In the attached images observe the flawless printing for the small brain, while the large brain suffers from artefacts starting from a certain height. Also, the belt of the motor on the back left gets loose every time, although I straightened it by pushing down the motor and fixing it by tightening its screws like hell.

Any ideas or suggestions would be highly appreciated!

Marc

IMG_2935.thumb.JPG.2e08210acb6b5078e88999a16dac30a3.JPG

IMG_2934.thumb.JPG.f958adc79d070950c52eaa326cacb891.JPG

IMG_2935.thumb.JPG.2e08210acb6b5078e88999a16dac30a3.JPG

IMG_2934.thumb.JPG.f958adc79d070950c52eaa326cacb891.JPG

    • Link to post
    Share on other sites
    Guest
    This topic is now closed to further replies.
     Share
    Go to topic listing

    • Our picks

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      • Ultimaker Cura 5.6 stable released

        Ultimaker Cura 5.6 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura now supports Method series printers!
         
        A year after the merger of Ultimaker and MakerBotQQ, we have unlocked the ability for users of our Method series printers to slice files using UltiMaker Cura. As of this release, users can find profiles for our Method and Method XL printers, as well as material profiles for ABS-R, ABS-CF, and RapidRinse. Meaning it’s now possible to use either Cura or the existing cloud-slicing software CloudPrint when printing with these printers or materials
        • 4 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...