I would love to come and check you guys out in action. I have just been bitten with the 3d printing bug and the Ultimaker so far is my number one choice to purchase. I have tons of questions.
I want to go.... I am from the Phoenix area, and Pasadena is just a short 5hr jaunt away.
That is unfortunate, well.. there are shows all over the world. Hopefully we'll see you in another show! Thanks!Sorry Can't be there.
Hopefully more luck next year :-)
Hi! Very last minute, but is it too late to snag some tickets? I plan to go today!
Thank you for the opportunity to attend this event. It was very educational. I received some good tips from the staff that was there.
-
1
Sorry, better luck next time!!Hi! Very last minute, but is it too late to snag some tickets? I plan to go today!
Did you end up going anyway?
You are very welcome, hopefully you had a good time!Thank you for the opportunity to attend this event. It was very educational. I received some good tips from the staff that was there.
What did you see at the show, and who did you talk to?
-
Our picks
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 18 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
Release Notes: S-Line Firmware 8.3.0 (Latest)
Dustin posted a topic in Firmware,
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.-
-
- 0 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Martijndewinter 0
Sorry Can't be there.
Hopefully more luck next year :-)
Link to post
Share on other sites