Jump to content
schneck007

prindhead travelling help

Recommended Posts

Posted · prindhead travelling help

I have following problem when I printing cubes the printhead travelling over the already printed areas which leads ugly matrial on it way over the areas. Retraction is enabled.

does anybody know if is there a setting in cura or a plugin which moves the head across before travelling

Share this post


Link to post
Share on other sites
Posted · prindhead travelling help

There is a retract while combing plugin that you can install.

you could just try turning combing off.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!