Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
gnafin

z-height adjustment

Recommended Posts

Hi, on my thing-o-matic we set the z-axis by putting a card or paper under the nozle.. turn the ballscrew till the card is tight then hit ok. and this sets the z-axis start height.... now this is with rep_g but can we have something like this for Cura? be nice.

Share this post


Link to post
Share on other sites

I think you just need to remove the Z homing from the start code for this. Right the start code assumes the Z0 position is at the endstop. But nothing stops you from messing with the start code to remove this.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 86 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!