Jump to content
Ultimaker Community of 3D Printing Experts

CPE


BrayChristopher

Recommended Posts

Sometimes if i'm printing really slow and hot i have fans on full but i make them full at 5mm

  • Link to post
    Share on other sites

    Please select the answer which helped you most as 'Best Answer'. It will help future readers find the appropriate answer as fast as possible. Thank you!

  • Link to post
    Share on other sites

    the profile should be in the new firmware.

    235 -250 deg

    65deg glass

    fans 50%

     

    I have tried, but couldn't find it in the settings. Isn't it released?

  • Link to post
    Share on other sites

    I have tried, but couldn't find it in the settings. Isn't it released?

     

    It was added (at the end of the list) in firmware version 14.12 with the name "UPET" and renamed to "CPE" since V15.04.1 (i think...).

    But there's also a limit of 16 entries, nothing will change if the limit is already reached.

  • Link to post
    Share on other sites

     

    I have tried, but couldn't find it in the settings. Isn't it released?

     

    It was added (at the end of the list) in firmware version 14.12 with the name "UPET" and renamed to "CPE" since V15.04.1 (i think...).

    But there's also a limit of 16 entries, nothing will change if the limit is already reached.

     

    Got my "problem". Cura said "no update available", but this was a problem in the Cura-Version. Got a new version and a new firmware now. Thanks.

     

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...