Jump to content
Ultimaker Community of 3D Printing Experts
Zapro

Drawings for Ultimaker 2 go?

Recommended Posts

Hi. A happy UMO-owner here :)

I'd like to build my own, customised Ultimaker 2 go-clone with a lot of inspiration from it. As far as i can see, all mechanical parts on it is identical to the ones on the 'Ultimaker 2' and 'Ultimaker 2 Extended' but i need the measurements on the case.

Will these drawings be made available at some point? I have looked on github and i can only find the drawings/source files for the 'Ultimaker 2'

// Per.

Share this post


Link to post
Share on other sites

@SandervG nice and punctual :) thanks!

I put a reply on the story page, but it seems to have been removed (no problem, if it was my site I would not even allow replies on those front pages at all anyhow) but I asked if you can also publish the assembly step file of the "GO" (as you also did with the UM2). All the individual parts are there but arranging them properly in CAD again is a bit of a pain and for you guy's it's probably a 2 minute job...

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!