-
Our picks
-
UltiMaker Cura 5.8 Stable released 🎉
MariMakes posted a topic in UltiMaker Cura,
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!-
- 3 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
Picked By
MariMakes, -
-
Recommended Posts
yellowshark 153
Hi David, you will no doubt get better answers from ABS experts but firstly I think your temp. is too low. I think 235/240 is about the minimum and people do go hotter. Also I get the feeling those two models are quite small, I would chop the speed to 30mm/s for starters and see how you go.
Link to post
Share on other sites