Jump to content
Ultimaker Community of 3D Printing Experts

Inconsistent M6 washers on Ultimaker Heated Bed Upgrade?


Recommended Posts

Posted · Inconsistent M6 washers on Ultimaker Heated Bed Upgrade?

Hey all,

I've recently received my Heated Bed Upgrade for the original Ultimaker, and during the installation, I ran into an issue with the washers that go with the thumb screws underneath the springs. One of them looks exactly as described in the instructions (thick, with a rounded side), but the other two are thin and flat (see attached picture). I proceeded to build with those anyway, greasing and installing the flat ones on the front (with the single rounded one on the back).

I expect this to not be a biggie (haven't had time to do the firmware upgrade and testing), but is there anything I'm missing? Should I replace them with proper washers? If so, how would I go about getting those?

Thanks!

IMAG1679.thumb.jpg.7a98d0953cfc4f3ada85bf720d380230.jpg

IMAG1679.thumb.jpg.7a98d0953cfc4f3ada85bf720d380230.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...