Vielen Dank Marcus für die gutes TIP !
Schonen Tag !
Ian 
Hi,
nicht aus Deutschland aber gehört zu den besten Filamentsorten in Europa (und glücklicherweise ist der Versand sehr günstig):
eins3d hat auch 2.75er im Angebot. Da nutze ich das ABS das is top.
vielen vielen dank !
Schone Grüsse aus München
Ian
They are located almost in GermanyHi,
nicht aus Deutschland aber gehört zu den besten Filamentsorten in Europa (und glücklicherweise ist der Versand sehr günstig):
- 1 year later...
Ich kaufe immer bei https://3d-filament.net und bin super happy.
Gruß
-
Our picks
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 16 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
Release Notes: S-Line Firmware 8.3.0 (Latest)
Dustin posted a topic in Firmware,
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.-
-
- 0 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
oceanblue72 5
Hallo,
da Du aus München kommst (wie ich), kann ich Dir auf jedenfall
FreeForm4U in der Auenstrasse empfehlen. Mittlerweile bekommt man dort auch Meterware, ideal wenn man z.B. neue Materialien / Farben ausprobieren will ohne gleich eine ganze Spule kaufen zu müssen.
Grüße
Marcus
Link to post
Share on other sites