Jump to content
Cura Connect | Survey Read more... ×
Ultimaker Community of 3D Printing Experts
LNCHAD

problème de fil cassé dans le tube guide

Recommended Posts

Bonjour,

Nouvelle utilisatrice de l'ultimaker 2, des petits problèmes persistent :

- dès que l'impression est fini, si mon filament reste dans le tube guide filament, il se casse !

est-ce normal ?

- et si oui, n'y-a-t-il pas d'autres moyens que de démonter le moteur pour "sortir" le filament de ce tube ???

Merci pour votre réponse, car je commence à désespérer sérieusement !-(

LN

Share this post


Link to post
Share on other sites

Bonjour chère compatriote :)

Le filament dont tu parles, quel est la marque? S'il casse c'est peut être un mauvais batch ou il a été mal entreposé (prise d'humidité?)/

Pour le sortir tu peux:

Faire change material, ce qui sortira le bout encore en contact avec le feeder. Et pour sortir le reste tu enleves le bowden des deux cotés (le bowden c'est le tube).

Pour enlever le tube, enlever le clip bleu et pousse sur le collet blanc puis tire sur le tube en maintenant poussé (ca doit venir tout seul, si tu dois forcer c'est que tu ne pousses pas assez). Ensuite prend un bout de filament et pousse le jusqu'a le sortir

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Architect Design Contest | People
      The goal of this contest is to design a set of people figurines that could be used in such a project to make an area, office or mall seem populated. 
      Think of different types of people in different environments, like walking people, people standing still, working people, and both men and women.
       
      • 8 replies
    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!