Any filaments you could staple?

[JUTAD 0]

I was just trying to think of a filament that i could somehow puncture with maybe staples or nails?

I tried the Woodfill PLA. it didn't work.

I'm not sure where you find such specifications for materials. Any ideas?

[neotko 1,417]

You could heat the nail orthe staple, or the printed area, and puncture it.

[ahoeben 1,948]

> I tried the Woodfill PLA. it didn't work.

What happened? I would guess the layers delaminated?

You could cheat and pre-drill, or heat up your nails/staples so the material gets a bit softer before being punctured.

Edit: too slow ;-)

Edited November 25, 2015 by Guest

[JUTAD 0]

Thanks so much for the answers!

I was using a normal stapler so it didn't really work. I tried with a tacker and 6cm staples.

The results were that the Woodfill PLA worked very well, however the PLA didn't work as well, the layers delaminated a little.

Thanks for the help

Woodfill:

PLA:

[IRobertI 520]

Well now you've got me curious. What's the purpose behind this?

[avogra 68]

staples are just a way to get small holes? or do you want to use the staples for what staples are for? I would guess that nylon works well for the second. but i dont know if the holes close themselves when you remove the staples. will try it when im back home on monday!