Jump to content
Ultimaker Community of 3D Printing Experts

Unexpected support towers from Cura


vvonplaten

Recommended Posts

Posted · Unexpected support towers from Cura

Hello UM community!

I get these weird tiny support towers overlapping my normal support, see attached image. The problem with these are that the retraction goes crazy and flattens my filament to the point where it causes under extrusion and eventually grinding. For now I turned off retraction but then I get stringing instead.

I haven't been able to find any setting in cura that affects this. Has anyone else had this problem?

5a33143850a63_ScreenShot2015-11-26at18_22_04.thumb.png.24d1ff49da25b636c5b8f0633d887e1b.png

Best regards,

Vilhelm

5a33143850a63_ScreenShot2015-11-26at18_22_04.thumb.png.24d1ff49da25b636c5b8f0633d887e1b.png

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...