Jump to content
Ultimaker Community of 3D Printing Experts
ForTheFuture

Hairy prints

Recommended Posts

Happy Thanksgiving Everyone! Hope this reaches you all in good health! I have a question about some of my prints. A few of the prints have what I'll call "hairy prints". Meaning that there are small pieces of material elongated like a hair that are stuck to say a base layer laid down. I've tried to modify the retraction settings but have not had much luck. What might be causing this? Thoughts anyone?

Thanks in advance!

Scott

Share this post


Link to post
Share on other sites

Any pictures?

Their are 2 types: Hair and stringing. It depends on which one of these you have.

Most Stringing can be fixed by Lowering printing temp, Increasing Retraction distance or Increasing travel speed. I would increase the retraction distance as a last resort as its good to keep these short. Make sure the bowden tube doesn't move on retracts first before increasing it as that may be a cause for needing the extra retract length.

Hairy Prints can be fixed by changing to a different color or material. Printing hotter or cleaning the Nozzle.

Share this post


Link to post
Share on other sites

Any pictures?

Their are 2 types: Hair and stringing. It depends on which one of these you have.

Most Stringing can be fixed by Lowering printing temp, Increasing Retraction distance or Increasing travel speed. I would increase the retraction distance as a last resort as its good to keep these short. Make sure the bowden tube doesn't move on retracts first before increasing it as that may be a cause for needing the extra retract length.

Hairy Prints can be fixed by changing to a different color or material. Printing hotter or cleaning the Nozzle.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!