Jump to content
Ultimaker Community of 3D Printing Experts

UMO+/UM2 fan speed controler broken/shorted


speedy555
 Share

Recommended Posts

Posted · UMO+/UM2 fan speed controler broken/shorted

hi so yes that happend i shorted my UMO+ speed controller and now the pwm fan output is giving 24v all the time

no way to turn it down i used the preheat config to change the fan speed but still 24v

i need help because i dont want to pay an other 300 euro to replace the board

thx

  • Link to post
    Share on other sites

    Posted · UMO+/UM2 fan speed controler broken/shorted

    If the cooling fan it's always on, the first think that dies it's the transistor

    https://ultimaker.com/en/community/11366-cooling-fan-always-on-umo-update-now-voltage-its-0

    It's isn't really easy to change, but I learned the hard way with a friend to do it and I have change it 3 times (crossing fingers).

    Read the post and also check my other post, at the end you will see photos of the transistor took off and the new installed. It's a very cheap part and if you don't know how to do it the first time I payed 30-40€ to a guy to do it for me (cheaper than a new board).

    https://ultimaker.com/en/community/17214-fan-pwm-output-0v-umo-board-solved-not-solved-?page=last

    Also, you could change the cooling fan connection to the led pwm, it has the same circuit, but to use it you need to rebuild the firmware and change the pins.h of the board.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • The Ultimaker Showcase — October 14. What's new?
        Your dear friends at Ultimaker have some exciting news and insights for you!
         
        • 0 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...