Jump to content
Ultimaker Community of 3D Printing Experts

Is this under extrusion?


Thadote
 Share

Recommended Posts

Posted · Is this under extrusion?

IMG_20151222_140957.thumb.jpg.1a5e5d7fff69c742cd05785eb78514cc.jpg

This happens from time to time. it mostly happens on the first layer after some infill.

Is this under extrusion? if so, what can I do to helt it? if not, what is it then?

The outher (and inner) surface looks good, there are no string, no deposits from oozing, I don't think there are any problems other than this, and it bothers me.

I had one time where the printer was printing in the air, this was due to a knot on the filament, but can this still course problems? because of the knot, the drive wheel was dirty, so I cleaned it, thus there should be no problem there.

The printer have (only) been running for a week, if that have anything to say..

IMG_20151222_140957.thumb.jpg.1a5e5d7fff69c742cd05785eb78514cc.jpg

  • Link to post
    Share on other sites

    Posted · Is this under extrusion?

    Hi,

    this doesn't look like under extrusion to me but rather the first "bottom" layer after some infill. If the photo depicts the finished object, then it is a huge problem. But if it is just printing one layer and then another few over that one, then it should be fine.

    However it could be that the nozzle is a bit clogged. Check out this guide about the atomic method:

    https://ultimaker.com/en/support/149-atomic-method

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...