Jump to content
Ultimaker Community of 3D Printing Experts

Starting print problems


Recommended Posts

Posted · Starting print problems

Hi

When I start A print it comes no filament from the nozzle until like 30seconds in.

That screws the bottom layer all the time.

But after a while it seems to work OK ..  

Cos I already printed A robot and now a wrench.

But its not top quality.

Out of ideas ,

  • Link to post
    Share on other sites
    Posted (edited) · Starting print problems

    but its weird everybody else on youtube seems gets it almost perfekt when it begins Printing.

    Think its something wrong with my machine then..´ It was a build kit . I can mention one thing the  heat sensor for the head was to short (wire). maybe they sent the wrong Cable?

    I Think it was made for the ultimaker 2 cos for me the Cable end only reached the middle back of my original.. Had to take it out from the tube and install it by a short cut in the front down the right bottom front hole..

    Edited by Guest
  • Link to post
    Share on other sites
    Posted · Starting print problems

    but its weird everybody else on youtube seems gets it almost perfekt when it begins Printing.

    Think its something wrong with my machine then..´ It was a build kit . I can mention one thing the  heat sensor for the head was to short (wire). maybe they sent the wrong Cable?

    I Think it was made for the ultimaker 2 cos for me the Cable end only reached the middle back of my original..  Had to take it out from the tube and install it by a short cut in the front down the right bottom front hole.. maybe messes with the temps ?

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...