Olsson block and error

[ffreak 1]

congratulations @ffreak I can still remember how frightened I was at the begining to take things apart, the new heater is a great improvement

good luck

 

hello stu_le_brew: indeed. As my UM was brandnew I was almost afraid of touching it.

Changing Olsson was allready a challenge, replacing the sensor and later on the heater were very scary situations to me.

The new heater is indeed a great improvement.

[gr5 2,167]

Be careful with hips. I'm told if you keep it at temperature in the nozzle for a few minutes it self clogs. So don't leave the nozzle hot with hips in it - always be printing or power down.

[ffreak 1]

Yo gr5, thx for your message.

And yes, I have encountered your remark.

My advice: remove the hips directly when printing is done: each time.

Compared to cleaning a nozzle, it's no effort loading the filament before printing .

The first testprints with hips were a dissaster: nozzle clogged each time.

By removing the hips after each print I have no problems anymore.

Furthermore, when removed the hips spool, I put the spool in a box with moisture absorber ...

[bob-hepple 59]

ffreak

well done a learning curve completed, bt don't worry there will be more coming around the corner.. Well Done.