About a ventilation system

[IRobertI 520]

I would assume those measurements are with and without the bowden tube.

edit: Beaten by Sander

Edited January 12, 2016 by Guest

[frederiekpascal 193]

Update, I asked for the shipping cost to Belgium.

Right now we are shipping to Belgium via Air. The Desktop units cost around $300/$400, the FreeStand, being twice the size, and weight, cost around $700/$800.

Very expensive shipping omg

[SandervG 1,521]

Still cheaper than the Z18

[CB1 0]

Hi smenguy,

We're looking at getting the same one.

Did you (or anyone else) order this? Any results?

[geert_2 557]

If only fume extraction is important, you could look into soldering fume extraction systems?

In the old days we had a sort of desktop bureau lamp with built-in fan and active carbon filter. No bigger than a normal desktop lamp. So you had a lot of light when soldering, and the fumes were taken away. But I don't know if active carbon filters out PLA and ABS fumes also. Just blowing them around, wouldn't improve safety...

(My Ultimakers are in a chemical fume extraction cabinet in our lab, since I have it anyway. Doesn't seem to cause problems with the draft for printing PLA.)