Jump to content
Ultimaker Community of 3D Printing Experts

Stops extruding after a while


FiddlingJoe
 Share

Recommended Posts

Posted · Stops extruding after a while

Hello all,

I read through a couple of the forums here, waw this sure is a community!

I just bought an Ultimaker 2+ but ran into a little hiccup.

I unpacked it, did a factory reset, leveled it. Fed it the grey PLA that was delivered with it and started to print the little cube-puzzle that was pre-installed on the SD card.

The first two parts of the cube it did wonderfully. I have them on my desk now and the quality is amazing.

At the third piece the nozzle suddenly stopped extruding. It was still moving as if it was printing but no PLA came out of the nozzle.

Before I start fidgeting around I thought I'd ask for advice first.

  • Link to post
    Share on other sites

    Posted · Stops extruding after a while

    apparently the filament I used that was delivered with the printer gets stuck sometimes. After using 2.85mm filament it printed with no issues whatsoever.

    Does anyone else have troubles with ultimaker 2+ and the grey filament that was included?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...