Jump to content
Ultimaker Community of 3D Printing Experts
gatonini

Adjusting Z axis steps per mm

Recommended Posts

Hi

Newbe here I attempted to adjust my z axis steps per mm because my prints were undersized on height please forgive me I'm an old machinist the parts were short by a 1/16 of a inch so I proceeded to adjust the steps according to directions I found online. Well I got to the point where the movement is correct now but the motors are running very fast now is this normal or is there something else I have to adjust ?

Thanks

Gary

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!