I'm having this same issue as of today. Printer was working perfectly before today. I've noticed when loading filament the feeder motor clicks and struggles to push filament through during normal Loading 2.85mm PLA Filament being loaded.
Once it gets loaded it prints out inconsistent layers
Recommended Posts
64games 0
Looking forward to hearing ideas. We are having the same problems but our will stop printing mid print too.
We've adjusted the tension, we've removed and replaced the filament, we've tried the Atomic Method. None of these have helped the situation.
Our printer is only a month old but my next step is looking at the PTFE coupler to see if all the issues has affected that.
Any other ideas would be welcome.
Link to post
Share on other sites