Jump to content
Ultimaker Community of 3D Printing Experts

Clogged Nozzle?


Plushberry
 Share

Recommended Posts

Posted · Clogged Nozzle?

I think the nozzle may be clogged becuase my prints are not staying on the build plate and the layers are not filling in correctly. I just printed a large object that took about a day and a half to complete in the colorfabb glow in the dark filament. I was going to start printing out the torque wrench to install the olson block but that's when i noticed the lack of print quality compares to previous prints. The large print came out just about fine but now the prints arent coming out at all.

  • Link to post
    Share on other sites

    Posted · Clogged Nozzle?

    Glow fill is very abrasive and you may have worn out your nozzle. You need to use hard nozzles when using glow fill.

    You can do an atomic pull to clean out any blockages in the nozzle if needed.

  • Link to post
    Share on other sites

    • 2 weeks later...
    Posted · Clogged Nozzle?

    i figured it out, the build plate was just not calibrated. afterwards ive printed many things with the glow fill and it works pretty well. now unfortunately the fillament has broken off inside the feeding tube and im not sure how to get it out.

  • Link to post
    Share on other sites

    Posted · Clogged Nozzle?

    I am having trouble getting the tube disconnected, i tried following the dissasembly instructions but the tube is giving me alot of resistance

     

    from what end are you struggling with?

    From the head, if you heat up the nozzle first then, loosen the 4 thumb screws. this makes it easier to come out if filament is stuck.

  • Link to post
    Share on other sites

    Posted · Clogged Nozzle?

     

    I am having trouble getting the tube disconnected, i tried following the dissasembly instructions but the tube is giving me alot of resistance

     

    from what end are you struggling with?

    From the head, if you heat up the nozzle first then, loosen the 4 thumb screws. this makes it easier to come out if filament is stuck.

     

    I was having trouble with both ends, but i didn't try loosening the thumb screws so ill try that next time.

  • Link to post
    Share on other sites

    Posted · Clogged Nozzle?

    If you loosen the thumb screws it allows you to push the bowden down a bit which can loosen it from the grip.

  • Link to post
    Share on other sites

    Posted · Clogged Nozzle?

    If you loosen the thumb screws it allows you to push the bowden down a bit which can loosen it from the grip.

     

    I was still having trouble with taking the tube out so i just fed it with more filament untill the broken end had been pushed out.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...