Jump to content
Ultimaker Community of 3D Printing Experts
amont

Olsson block nozzle problems

Recommended Posts

Having fitted a new nozzle to my Olsson block last week the printer under extruded.

I fitted the original one again and it printed OK.

Suspicious, I have tried to pass 0.3 micro drill through the new nozzle and it will not go.

I believe these spare nozzles (which I bought last June) are 0.25 and not the 0.4 I ordered.

I am going to attempt to drill them out.

Others have posted about under extrusion with the Olsson block and I believe they should check this possibility.

Edited by Guest

Share this post


Link to post
Share on other sites

There is one dot on the nozzle.

Since my original post I have found another thread https://ultimaker.com/en/community/8689-custom-heater-block-to-fit-e3d-nozzle-on-ultimaker-2-the-olsson-block page 30 which refers to considerable confusion regarding the nozzle markings and the fact that some wrong sizes were sent out.

I must be the recipient of some of that batch.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!