Jump to content
Ultimaker Community of 3D Printing Experts

looking for cura setting


Recommended Posts

Posted · looking for cura setting

Most likely you are not extruding enough material. This could be mechanical (filament slipping in your drive), your filament diameter setting could be wrong, or you could adjust the steps-per-e in the preferences to a higher value.

  • Link to post
    Share on other sites
    Posted · looking for cura setting

    I recognize these problems, and guess that your belt tension is not yet correct.

    Check this

    by ultimaker

    You should soon see that the harmonic vibration of your belts isn't high pitched enough

    !!edit!!

    Mind that the correct belt tension should resemble about 7mm when u push it in the middle.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...