Jump to content
Ultimaker Community of 3D Printing Experts

Ultimaker 2 crashes after message 11/21 when calibrating.


Horsiris
 Share

Recommended Posts

Posted · Ultimaker 2 crashes after message 11/21 when calibrating.

Hello,

My Ultimaker 2's nozzle was clogged and I had top open it and clean it, but before this I also had the crash. When I cleaned it I put it all back together and started it up. Once started up I went to Material and then change. As soon as I hit that, the printer fails and crashes. So I was dumb enough to do a Factory Reset. So now evreytime I am at message 11/21 It chrashes and shuts itself off.

the message 11/21:

"Now that we leveled

the buildplate

the next step is

to insert material."

As I press Continue it crashes.

Thanks in advance,

Jeroen

(U mag ook in het Nederlands reageren)

  • Link to post
    Share on other sites

    Posted · Ultimaker 2 crashes after message 11/21 when calibrating.

    Hi Jeroen,

    What do you mean by crashes? Does it reboot itself, or you can not continue in the wizard?

    - If you prefer to communicate in Dutch, we also have a Dutch section on our forums where all of our Dutch friends hang out. In this section English is the desired language.

  • Link to post
    Share on other sites

    Posted · Ultimaker 2 crashes after message 11/21 when calibrating.

    Hi Horsiris,

    Thank you for your post.

    I have double checked with our technical department. I think it might be your electronics that short circuited but let me double check first.

    Your last post completely missed my radar, our apologies for the inconvenience.

    Will report back asap :)

    - Have you also been in touch with your reseller?

  • Link to post
    Share on other sites

    Posted · Ultimaker 2 crashes after message 11/21 when calibrating.

    Good thing I checked, I got an unanimous conclusion that it most likely is a short circuit in your heater cartridge. I would suggest to get in touch with your reseller to have it replaced.

    Thank you for your time and patience!

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...