Jump to content
Ultimaker Community of 3D Printing Experts
martin7025cc

Z-Stage Problems

Recommended Posts

Hi,

Two years ago i bought the original heated build plate for the Ultimaker original from ultimaker. Now a couple of weeks ago i was able to come back to 3D printing and install the new Z-Stage but now i have a Problem.

The first try to Print was horrible, the part was 10mm high in the design but the print was nearly 30mm high. Then i checked the Z movement by a sliding caliper and it was totally wrong.

I Tried to figger out the correct steps/mm value but i think i'm not 100% correct. Currently is it to +200,6 but when I print designers higher the approximately 30mm the the bond of the layers go worse.

So could please give me somebody the information of the correct steps/mm setting an also oft he jumpering of the Z-Motor drive?

Im not quite sure what is wrong the value or the jumpering.

Thanks.

Ragards

Martin

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!