Jump to content
Ultimaker Community of 3D Printing Experts

MAXTEMP triggered error


sven1729
 Share

Recommended Posts

Posted · MAXTEMP triggered error

Hi,

I keep getting the following error while printing:

Error:0

: Extruder switched off. MAXTEMP triggered !

Error:Printer stopped deu to errors. Fix the error and use M999 to restart!. (Temperature is reset. Set it before restarting)

I'm running Ultimaker on Marlin firmware controlled from PrintRun.

After this error is shown, I cannot issue any commands to Ultimaker anymore and need to reset it. Then it works for a while until the error shows up again.

Anybody has seen as well? Googling the error didn't produce much...

  • Link to post
    Share on other sites

    Posted · MAXTEMP triggered error

    It indicates you have a problem with the temperature sensor. Double check if the yellow and red wire on top of the head are screwed in tightly, and the 3 point cable connection is firmly attached.

  • Link to post
    Share on other sites

    Posted · MAXTEMP triggered error

    Hi Sven,

    You can read into this topic, i think it should give you some help:

    viewtopic.php?f=8&t=1083

    If you are unsure, you can post some pictures of your signal cabe (the red yellow black wires).

    Are your thermocouple and cartridge heater not interfering with eachother at the hot end?

  • Link to post
    Share on other sites

    Posted · MAXTEMP triggered error

    Thanks for the input and quick replies. I had the time to test it out in the meantime.

    The cables were connected correctly, but I still unplugged the three wire plug and plugged it back in. I suspect that it may have gotten some unwanted tension as I don't run the cables in parallel with Bowden tube since I had a plug. I have changed this now.

    The other thing I noticed was the that heat shield around the thermocouple was touching the back of the heating element. I separated them and since then it has been printing fine. Don't know if this is indeed heat transfer to the thermocouple via the braided heat shield or maybe EMI.

    Sven

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...