Jump to content
Ultimaker Community of 3D Printing Experts

Inaccuracy when printing


clinton
 Share

Recommended Posts

Posted (edited) · Inaccuracy when printing

I'm printing a fairly long length item which uses supports only (I tried a brim too but that made no difference).

I have designed the shape in Fusion360 and it is drawn like this:

Drawing.png.2740ceb0aef43199601fa1e4b6f13ebe.png

but when I print it I get this

Print.thumb.jpg.69c08bcfeb3a52968af83b9f9be724d1.jpg

It's printed flat with the posts pointing upwards and the support structure between the ledge and the glass.

printing.thumb.jpg.8c5d87ab3990b13cdd5ebf6de418d609.jpg

It seems worse at each end. The middle of the item isn't too bad. Could it be a calibration issue with the Ultimaker?

Drawing.png.2740ceb0aef43199601fa1e4b6f13ebe.png

Print.thumb.jpg.69c08bcfeb3a52968af83b9f9be724d1.jpg

printing.thumb.jpg.8c5d87ab3990b13cdd5ebf6de418d609.jpg

Edited by Guest
  • Link to post
    Share on other sites

    Posted · Inaccuracy when printing

    Could it be a calibration issue with the Ultimaker?

     

    I doubt it. It's more likely related to the material (which one is it?).

    Looking at your model - i assume that the material shrinks at different rates. Those geometries are hard to print (at least in this orientation). If possible, add some reinforcements on the sides and/or below the ledge, or try thicker walls. This may help a bit.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 8 replies
    ×
    ×
    • Create New...