Jump to content
Ultimaker Community of 3D Printing Experts

Woodfill not sticking to bed? Any ideas?


Recommended Posts

Posted · Woodfill not sticking to bed? Any ideas?

Hey guys

I'm trying gizmo dorks woodfill, but I can't seem to get it to stick to the bed. I've tried blue tape and 60c heated bed. Does anyone have experience with sticking woodfill to beds?

Thanks

Alex

  • Link to post
    Share on other sites
    Posted · Woodfill not sticking to bed? Any ideas?

    Did you clean the Blue tape with isopropyl alcohol to remove the wax coating?

    You may need to up the temp a little.

    I normally use Glue on the heated bed. It is a bit hard sometimes to get it to stick.

  • Link to post
    Share on other sites
    Posted · Woodfill not sticking to bed? Any ideas?

    I never use blue tape for woodfill... What are your print settings?

     

    I'll get them tonight.....

  • Link to post
    Share on other sites
    Posted · Woodfill not sticking to bed? Any ideas?

    Correct.

     

    Ok. I've got it to adhere to the tape with alcohol, somewhat. Maybe should I slow down the first layer? I know people say if you leave the filament in the hot end for too long it'll burn, but how long does it actually take to burn?

  • Link to post
    Share on other sites
    Posted · Woodfill not sticking to bed? Any ideas?

    Not very long but as long as it's moving a find it ok.

    What temps, initial layer height and speed r u using?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...