Jump to content
Ultimaker Community of 3D Printing Experts
swq0603

About Axes Lubricating

Recommended Posts

I have been using the ultimaker to printing many models. Now I want to lubricate my axes. But from the user manual I found that for X/Y axes, I must use the sewing machine oil, but for Z axes, the grease included in the package is fine. I just a little curious why the sewing machine oil is a MUST for X/Y axes. Thank a lot.

Share this post


Link to post
Share on other sites

x/y and head x/y oil yes. The two z smooth NOTHING at all or the linear bearings of the bed will get problems as soon it dry inside and will block them (z banding) and for the Z middle one (the one not smooth that it's from the z motor) just lube.

Share this post


Link to post
Share on other sites

Many reasons

It needs thin oil as they have sintered bearings which are porous and absorb the thin oil.

If grease is used then they will gum up.

Dust will also stick to the grease and make it worse.

The axis move fast and grease will put to much strain on them, where the x axis just rotates a small amount.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!