Jump to content
Ultimaker Community of 3D Printing Experts

"Temperature measurement failed"


infinityvisions

Recommended Posts

Posted · "Temperature measurement failed"

I assembled the printer without any problems and it was a fun experience.

When trying to download the software Replicator G. there is no link anymore to this software only to Cura 12.10.

So we downloaded Cura in a W7 32 bit machine and run the Ultimaker Checkup multiple times getting an error "Temperature measurement failed"

I installed also in a Mac and we got the same results.

I looked in the forum and rechecked all the wire connections that were Ok, and also measured the two white heater wires and got 9.4 Omhs.

Whys the Checkup is failing? Any advise?

Thanks

  • Link to post
    Share on other sites
    Posted · "Temperature measurement failed"

    Is the powerbrick connected and the main power on? (the fan at the bottom should be spinning)

    (Note, Cura has become the default software for the Ultimaker, we still need to update some references to RepG on the wiki)

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...