Jump to content

UM2+ not working

slouchcorp

By slouchcorp
in UltiMaker 3D printers

 Share

Recommended Posts

slouchcorp

slouchcorp 2

Posted
  • Author
Posted · UM2+ not working

Didnt look like there was anything wrong with your printer dude. It looked like a slow jam where your nozzle was slightly blocked, or it was in a room that was too cold or something. A couple good atomic pulls would have sorted that. You will get that exact problem again if your not careful......

 

I spent hours doing just that over and over I did everything I could find info on, and it never did a single print that worked. that was straight out of the box, in a warm room. the replacement worked instantly. so I do think there was an issue with it.

    • Link to post
    Share on other sites
    cloakfiend

    cloakfiend 995

    Posted
    Posted (edited) · UM2+ not working

    Fair enough but youll get issues like that from time to time if your not careful anyways, especially at the start if your learning. Took me months to figure stuff out. I thought my printer was broken many times. Luckily it wasnt. I dont have yours in front of me so i cant really say for sure.

    Edited by Guest
    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...